Table of Contents
Advertisement
Camera title
The camera title entered for "Camera title" on the [Basic] tab will be displayed. (®page 51)
Alarm occurrence indication button
When an alarm occurs, the display flashes. When this button is clicked, this button will disappear.
(®page 24)
Note
•
Since the blinking of the alarm occurrence indication button is not coupled to recording images
to the SD memory card, forwarding E-mails, or other operations, check the settings of each
operation separately.
SD recording status indicator
The status of the SD recording can be checked with this indicator. When the SD recording starts, the
SD recording status indicator will light red. It will go off when the SD recording stops.
This indicator will be displayed when "Manual" or "Schedule" is selected for "Save trigger" on the setup
menu. (®page 57)
Main area
The live images from the camera will be displayed in this area.
Remaining capacity
Displays the remaining capacity and total capacity of the SD memory card.
Super Dynamic setting
Select "On" or "Off" to determine whether or not to activate the super dynamic function. Refer to the
description "Super Dynamic function" (®page 73) about the super dynamic function.
On: The super dynamic function will work.
Off: The super dynamic function will not work.
Default: On
Note
•
When the following are observed depending on the light condition, select "Off" for "Super
Dynamic(SD)".
–
When flickering appears or the color changes on the screen
–
When noise appears in the brighter area on the screen
[Light control mode] pull-down menu
Select the light control mode from the following.
Indoor scene (50 Hz)/Indoor scene (60 Hz): The shutter speed will automatically be adjusted to
prevent flicker caused by fluorescent light. Select 50 Hz or 60 Hz corresponding to the location where
the camera is in use.
ELC: Uses shutter speed adjustment to control light.
Default: ELC
Note
•
When 25fps mode is selected for [Image capture mode], "Indoor scene (60 Hz)" is not available.
Image rotation
Sets whether or not to rotate the image.
0 °(Off): Do not rotate the image.
90 °: Rotate the image 90 degrees.
180 °(Upside-down): Flip the image upside down.
270 °: Rotate the image 270 degrees.
Default: 0 °(Off)
IMPORTANT
•
The position shifts if the image rotation setting is changed when the following area settings are
configured. Therefore, configure the settings for each area after configuring the image rotation.
–
Mask area
*2
1 Operations
Operating Instructions
19
Advertisement
Table of Contents
