Table of Contents
Advertisement
2 Settings
[Status]
The port forwarding status will be displayed.
[Router global address]
The global address of router will be displayed.
Self check
The self check result of the hardware will be displayed.
Note
•
Refer to our website (https://security.panasonic.com/training_support/support/info/ <Control
No.:C0111>) for further information about the contents of the displayed statuses (relating to the
"Viewnetcam.com" service, the UPnP function, or the self check).
SD memory card
[Model no.]
Displays the model number of the SD memory card.
If model number information could not be obtained, "Read error" is displayed. If the SD memory card is not
used, "Not use" is displayed. In other cases "Unknown" is displayed.
[Serial no.]
Displays the serial number of the SD memory card.
If the serial number information could not be obtained, "Unknown" is displayed.
[Remaining capacity]
Displays the remaining capacity and total capacity of the SD memory card.
This is the same information that is displayed in [Remaining capacity] of the SD memory card information on
the [SD memory card] tab of the "Basic" page.
[Total use time]
Displays the length of time that SD memory card has been inserted into and used with the camera.
If the length of time that the SD memory card has been used for cannot be obtained, "Unknown" is displayed.
"Total use time" is updated once per hour.
[Number of overwrite times]
Displays the number of overwrite times as calculated from the total capacity of the SD memory card, the number
of times the camera has written files to the SD memory card, and the file sizes.
If the number of overwrite times cannot be calculated, "Unknown" is displayed.
Note
•
Because the overwrite time values are just estimates calculated by the camera, they may differ to the
actual number of overwrite times.
[No.] / [Time & date] / [Description] of the log
Displays the log related to the SD memory card.
166
Operating Instructions
Advertisement
Table of Contents
