Reboot The Access Point From The Local Browser Ui - NETGEAR WAX214 User Manual

NETGEAR WiFi 6 AX1800/AX3600 Dual Band PoE/PoE+ Access Points, WAX214 and WAX218
c. Select the firmware file.
6. Click the Upload button.
The page displays the upgrade progress.
WARNING: To avoid the risk of corrupting the firmware, do not interrupt the
upgrade. For example, do not close the browser, click a link, or load a new page.
Do not turn off the access point. Wait until the access point finishes.
When the upgrade is finished, the login page displays. The firmware version displays
on the login page.
Reboot the access point from the local
browser UI
You can use the local browser UI to reboot the access point. This is very useful if you
manage the access point remotely or the access point is installed at a location that is
not easy to reach.
To reboot the access point from the local browser UI:
1. Launch a web browser from a computer or mobile device that is directly connected
over WiFi to the access point or connected to the same network as the access point.
2. Enter the IP address that is assigned to the access point.
If you are directly connected to the "CONFIG-ONLY" SSID, you can enter
https://www.aplogin.net.
A login window displays.
If you do not know the IP address, see Find the IP address of the access point on
page 33. For more information about the "CONFIG-ONLY" SSID, see 2.4 GHz
management SSID on page 58.
If your browser does not display a login window but displays a security message and
does not let you proceed, see Log in to the access point after you complete the initial
log-in process on page 35.
3. Enter the access point local device password and click the Login button.
The local device password is the one that you specified. The password is
case-sensitive.
The Device Status page displays.
4. At the top right of the page, select the Reset tab.
Maintain the access point 91 User Manual