Connect To The Access Point Over The Lan And Log In For The First Time - NETGEAR WAX214 User Manual

NETGEAR WiFi 6 AX1800/AX3600 Dual Band PoE/PoE+ Access Points, WAX214 and WAX218
you can continue to use to log in over a WiFi connection to the local browser UI
of the access point.
In addition to the management SSID, the access point supports four WiFi networks.
By default, only the main WiFi network is enabled.
c. In the Passphrase field, specify a passphrase (WiFi password) for the main WiFi
network.
This passphrase must be a minimum of 8 characters and can be a maximum of
63 characters.
This passphrase does not replace the passphrase for the management SSID,
which you can continue to use to log in over a WiFi connection to the local browser
UI of the access point.
d. Select the check box to accept NETGEAR's terms and conditions and acknowledge
that you read the privacy notice.
e. Click the Apply button.
Yous settings are saved. The access point restarts. After about two minutes, the
login page displays.
5. If you are still connected to the management SSID but the login page does not
display, in the address field of your web browser, enter https://www.aplogin.net.
Note: If your browser displays a security message and does not let you proceed,
see Step 3.
6. In the Local Device Password field, enter your new local device password, and click
the Login button.
The Device Status page displays. You can now configure the access point for your
network and environment.
Connect to the access point over the LAN and log in for
the first time
The following procedure assumes that your network includes a DHCP server (or router
that functions as a DHCP server) and that the access point and your computer are on
the same LAN. By default, the access point functions as a DHCP client and receives an
IP address from a DHCP server.
Installation and Initial Log-in 29 User Manual