Change The Language - NETGEAR WAX214 User Manual

NETGEAR WiFi 6 AX1800/AX3600 Dual Band PoE/PoE+ Access Points, WAX214 and WAX218
• Microsoft Edge: If Microsoft Edge displays a There is a problem with this website's
security certificate message or a similar warning, select Details > Go on to the
webpage.
To log in to the access point's local browser UI after you complete the initial log-in
process:
1. Launch a web browser from a computer or mobile device that is directly connected
over WiFi to the access point or connected to the same network as the access point.
2. Enter the IP address that is assigned to the access point.
If you are directly connected to the "CONFIG-ONLY" SSID, you can enter
https://www.aplogin.net.
A login window displays.
If you do not know the IP address, see Find the IP address of the access point on
page 33. For more information about the "CONFIG-ONLY" SSID, see 2.4 GHz
management SSID on page 58.
If your browser does not display a login window but displays a security message,
see the information in the introduction to this task.
3. Enter the access point local device password and click the Login button.
The local device password is the one that you specified. The password is
case-sensitive.
The Device Status page displays.
The Device Status page displays various panes that let you see the status of your access
point at a glance. You can now configure and monitor the access point.

Change the language

By default, the language of the local browser UI is set as Auto. You can change the
language.
To change the language:
1. Launch a web browser from a computer or mobile device that is directly connected
over WiFi to the access point or connected to the same network as the access point.
2. Enter the IP address that is assigned to the access point.
If you are directly connected to the "CONFIG-ONLY" SSID, you can enter
https://www.aplogin.net.
A login window displays.
Installation and Initial Log-in 36 User Manual