NETGEAR WAX214 User Manual page 106

NETGEAR WiFi 6 AX1800/AX3600 Dual Band PoE/PoE+ Access Points, WAX214 and WAX218
The local device password is the one that you specified. The password is
case-sensitive.
The Device Status page displays.
4. Under Management, select Advanced.
The page displays the advanced settings with the Management Mode section at the
top.
5. In the Email Alert section, configure the following settings:
a. Select the Status Enable check box.
The field and menus become available.
b. In the From field, enter the originating email address.
c. In the To field, enter the email address of the recipient.
d. In the Subject field, enter the subject information of the email or leave the default
subject information.
The subject information depends on the model and the MAC address, indicated
in the following default subject information by [XX:XX:XX:XX:XX:XX]:
• WAX214: [Email-Alert][WAX214][XX:XX:XX:XX:XX:XX] Configuration Changed
• WAX218: [Email-Alert][WAX218][XX:XX:XX:XX:XX:XX] Configuration Changed.
e. In the Username field, enter the user name to access the originating email
account.
f. In the Password field, enter the password to access the originating email account.
g. In the SMTP Server field, enter the name of the outgoing email server name.
h. In the Port field, enter the port number that the access point uses to contact the
SMTP server.
By default, the port number is 25.
i. From the Security Mode menu, select one of the following options, depending
on the security that the SMPT server uses:
• None: The SMPT server does not use security. This is the default setting.
• SSL/TLS: The SMPT server uses the SSL or TLS security protocol
• STARTTLS: The SMPT server uses the STARTTLS security protocol.
6. To send a test email, click the Send Test Mail button.
7. Verify that the recipient receives the email.
8. Click the Apply button.
Your settings are saved and applied.
Maintain the access point 106 User Manual