NETGEAR WAX214 User Manual page 88

NETGEAR WiFi 6 AX1800/AX3600 Dual Band PoE/PoE+ Access Points, WAX214 and WAX218
4. Under Network, select Wireless.
The Wireless Settings page displays.
5. Scroll down to the Guest Network DHCP Server Settings section.
You can change the DHCP server settings for a guest network only if you enabled
at least one guest network on an SSID. Otherwise, the fields are masked out.
6. Configure the settings that are described in the following table, keeping in mind
that the IP address, starting IP address, and ending IP address must be in the same
range.
The manual IP settings define the IP address and subnet mask for the DHCP server.
The automatic DHCP server settings define the range of IP addresses from which
the DHCP server automatically assigns an IP address.
Setting
Manual IP Settings
IP Address
Subnet Mask
Automatic DHCP Server Settings
Starting IP Address
Ending IP Address
WINS Server IP
7. Click the Save button.
Your settings are saved but not yet applied.
A pop-up window displays. The window shows the number of changes to be applied.
8. In the pop-up window, click the Apply button.
Your changes are applied. If the WiFi link must be reestablished, the page displays
the number of seconds before the access point is back online.
Manage the Advanced WiFi and
Radio Settings
Description
The IP address for the guest network. The default IP address is 192.168.200.1.
The subnet mask associated with the IP address. The default subnet mask is
255.255.255.0.
The starting IP address in the address range from which a WiFi client on a guest
network can be assigned an IP address. The default starting IP address is
192.168.200.100.
The ending IP address in the address range from which a WiFi client on a guest
network can be assigned an IP address. The default ending IP address is
192.168.200.200.
The IP address of an optional Windows Internet Name Service.
88 User Manual