Control The Leds - NETGEAR WAX214 User Manual

NETGEAR WiFi 6 AX1800/AX3600 Dual Band PoE/PoE+ Access Points, WAX214 and WAX218
If your browser does not display a login window but displays a security message and
does not let you proceed, see Log in to the access point after you complete the initial
log-in process on page 35.
3. Enter the access point local device password and click the Login button.
The local device password is the one that you specified. The password is
case-sensitive.
The Device Status page displays.
4. Under Network, select Wireless.
The Wireless Settings page displays.
5. Scroll to the Management VLAN Setting section at the bottom of the page.
6. Click the Status Enable radio button.
7. In the field that becomes available, enter the ID of the management VLAN.
8. Click the Save button.
Your settings are saved but not yet applied.
A pop-up window displays. The window shows the number of changes to be applied.
9. In the pop-up window, click the Apply button.
Your changes are applied. If the WiFi link must be reestablished, the page displays
the number of seconds before the access point is back online.

Control the LEDs

By default, all LEDs are enabled and function as described in Top panel with LEDs for
model WAX214 on page 12 or Top panel with LEDs for model WAX218 on page 17.
You can manage whether the LEDs light at all. This function is useful if you want the
access point to function in a dark environment.
To control the LEDs:
1. Launch a web browser from a computer or mobile device that is directly connected
over WiFi to the access point or connected to the same network as the access point.
2. Enter the IP address that is assigned to the access point.
If you are directly connected to the "CONFIG-ONLY" SSID, you can enter
https://www.aplogin.net.
A login window displays.
Maintain the access point 109 User Manual