Enable Snmpv1 And Snmpv2 And Manage The Settings - NETGEAR WAX214 User Manual

NETGEAR WiFi 6 AX1800/AX3600 Dual Band PoE/PoE+ Access Points, WAX214 and WAX218
access point by using the SNMPv1, SNMPv2, or SNMPv3 protocol. By default, SNMP is
disabled on the access point.
SNMPv1 and SNMPv2 support groups that can manage traps that the SNMP agent
generates. SNMPv3 supports users that can do the same but can provide a higher level
of security through authentication and encryption.

Enable SNMPv1 and SNMPv2 and manage the settings

You can enable SNMPv1 and SNMPv2 and manage the associated settings for the access
point:
To enable SNMPv1 and SNMPv2 and manage the settings:
1. Launch a web browser from a computer or mobile device that is directly connected
over WiFi to the access point or connected to the same network as the access point.
2. Enter the IP address that is assigned to the access point.
If you are directly connected to the "CONFIG-ONLY" SSID, you can enter
https://www.aplogin.net.
A login window displays.
If you do not know the IP address, see Find the IP address of the access point on
page 33. For more information about the "CONFIG-ONLY" SSID, see 2.4 GHz
management SSID on page 58.
If your browser does not display a login window but displays a security message and
does not let you proceed, see Log in to the access point after you complete the initial
log-in process on page 35.
3. Enter the access point local device password and click the Login button.
The local device password is the one that you specified. The password is
case-sensitive.
The Device Status page displays.
4. Under Management, select Advanced.
The page displays the advanced settings with the Management Mode section at the
top.
5. In the SNMP Settings section, select the Status Enable radio button.
By default, the SNMP settings are masked out and the Status Disable radio button
is selected.
6. Configure the SNMPv1 and SNNPv2 settings as described in the following table:
Maintain the access point 99 User Manual