Reboot The Access Point From The Local Browser Ui - NETGEAR WAX610 User Manual

Insight Managed WiFi 6 AX1800 Dual Band Access Point WAX610 User Manual
the access point's MAC address (or the system name), dd is the date, mm is the
month, yy is the year, hh is the hour (in 24-hour format), mm is the minutes, and ss
is the seconds.
An example of a name of a backup file is
WAX6XX-NETGEAR1A2B3C-03-06-20_16-45-35-config.tar.
6. Click the Restore button.
A pop-up window opens.
7. Enter the password that you specified when you saved the backup file, and click the
Continue button.
8. Click the Restore button.
The pop-up window closes and the configuration is uploaded to the access point.
When the restoration is complete, the access point reboots. This process takes about
two minutes.
WARNING: To avoid the risk of corrupting the firmware, do not interrupt the
restoration. For example, do not close the browser, click a link, or load a new page.
Do not turn off the access point. Wait until the access point finishes restarting and
the Power/Cloud LED turns solid green or solid blue.
Reboot the access point from the local
browser UI
If you cannot physically access the access point to reboot it (that is, disconnect the power
and reconnect the power), you can use the local browser UI to reboot the access point.
To reboot the access point:
1. Open a web browser from a computer that is connected to the same network as the
access point or directly to the access point through an Ethernet cable or WiFi
connection.
2. Enter the IP address that is assigned to the access point.
A login window opens.
If your browser does not open the login window but displays a security message
and does not let you proceed, see Log in to the access point after initial setup on
page 37.
3. Enter the access point user name and password.
Manage and Maintain the Access
Point
158 User Manual