Factory Default Settings - NETGEAR WAX214 User Manual

NETGEAR WiFi 6 AX1800/AX3600 Dual Band PoE/PoE+ Access Points, WAX214 and WAX218

Factory default settings

You can reset the access point to the factory default settings, which are shown in the
following table.
For information about resetting the access point to its factory settings, see Reset the
access point to factory default settings on page 95.
Table 12. Factory default settings model WAX214 and model WAX218
Feature
Access
Default IP address
DHCP client
Local device password
2.4 GHz management SSID
Model WAX214
Model WAX21
WiFi passphrase for
management SSID
Management SSID time-out
WiFi networks (SSIDs) for client connections
5 GHz SSIDs
SSID (settings for each individual SSID)
Guest network
Factory Default Settings and
Technical Specifications
Default Setting
192.168.0.100 (aplogin.net)
Enabled.
Note: If connected to a network, the access point receives an IP address from a
DHCP server or router in the network.
No default password. The first time that you log in to the local browser UI, you must
define a local device password that applies only to local browser UI access.
WAX214XXXXXX-CONFIG-ONLY
XXXXXX represents the last six digits of the MAC address of the LAN interface of
the access point.
WAX218XXXXXX-CONFIG-ONLY
XXXXXX represents the last six digits of the MAC address of the LAN interface of
the access point.
The unique WiFi password is printed on the access point label. The security is
WPA2-Personal.
Automatically turned off after15 minutes of being idle.
By default, the first SSID is enabled after you specify the name and WiFi passphrase
the first time that you log in to the local browser UI.
The second, third, and fourth SSIDs are disabled by default:
NETGEARXXXXXX_2
NETGEARXXXXXX_3
NETGEARXXXXXX_4
XXXXXX represents the last six digits of the MAC address of the 2.4 GHz radio of
the access point. When you enable one of these SSIDs, the default WiFi passphrase
is sharedsecret and the default security is WPA2-Personal.
Disabled
137 User Manual