Symbol MK1000 Product Reference Manual page 95

Wireless Ethernet - Radio Status Settings
From the RF Network Settings screen, press the Previous or Next buttons to move the "<"
cursor to the Radio Status option and press the Enter button to display the Radio Status
screen.
Figure 3-42. Wireless Ethernet Config - Radio Status Screen
The Radio Status screen is only available when an 11MB radio is installed. The contents of
the Radio Status screen are valid only when the TCP/IP Interface is set to "Wireless
Ethernet," the Wireless Ethernet Configuration is set to "Enabled," and the MK1000 was
powered up with these two options already set. If these options were not set, the values
displayed are all zeroes.
To return to the RF Network Setting screen, press the '1' button to escape.
Field Name
Note: All fields on this screen are read only.
RF Mac
RF Mac: 00:00:00:00:00:00
AP Mac: 00:00:00:00:00:00
Link : DOWN
Chan : 0
TxRate: 1Mbps
Port : Err
(Figure 3-42 shows the values of inactive Radio Status screen.)
Table 3-17. Radio Status Screen Definitions
This field includes the MAC address of the installed
Symbol LA-41x1 802.11b RF PCCard.
If the TCP/IP interface is not set to "Wireless
Ethernet" and the Wireless Ethernet Configuration
is not set to "Enabled" prior to powering up the
MK1000, the value in this field is 0.
This field is read only.
Setup and Installation: Communication
CQ: 0
ASL: 0
ANL: 0
<
Description
3-49