Reactivated/Host Connection Established Message; Display Control Characters - Symbol MK1000 Product Reference Manual

Reactivated/Host Connection Established Message

This default message displays once the station has received polls from the host, or if a host
connection is established after being out of service.
Figure 5-3. Reactivated/Connection Established Message

Display Control Characters

The following control characters are supported within display messages. Note that the
exact position of the cursor after a VT, FF, or CR depends on the size of the currently
selected font.
Control Character
VT
FF
CR
SO
SI
* READY *
Scan Item
Table 5-3. Display Control Characters
Hex Representation
0BH
0CH
0DH
0EH
0FH
Function
Clear display & go to top left position
Clear display & go to top left position
Go to left-most position of next line
Shift Out: Set the shift state that causes
the most significant bit of all
subsequent characters to be flipped.
This allows 7-bit systems to access
codes 160-255, and 8-bit systems to
access codes 0-31. Note: Codes 0-3
are not shifted.
Shift In: Resets the shift state set by the
Shift Out code. The shift state is also
reset at the end of every packet sent to
the MK1000.
PCK Emulation
5-9