Replacing The Left Side 4X 2.5-Inch Hdd Backplane - Fujitsu PRIMERGY RX1330 M5 Upgrade And Maintenance Manual

Preliminary steps
▶
"Locating the defective server" on page
▶ If applicable,
"Removing the front cover with lock" on page
▶
"Locating the defective component" on page
Removing the defective 2.5-inch HDD/SSD module
▶ Remove the HDD/SSD module, see
module" on page
▶ If applicable, remove the HDD/SSD from the installation frame, see
"Handling HDDs or SSDs without installation frame" on page
Installing the new 2.5-inch HDD module
▶ If applicable, install the HDD/SSD in the installation frame, see
HDDs or SSDs without installation frame" on page
▶ Install the HDD/SSD module, see
on page 140.
Concluding steps
▶ If applicable,
"Installing the front cover with lock" on page
▶ If the HDD/SSD is configured using a RAID controller with a RAID level
higher than "0", the rebuild will start automatically, see
array rebuild" on page
7.5.5

Replacing the left side 4x 2.5-inch HDD backplane

Field Replaceable Unit
(FRU)
Tools: tool-less
RX1330 M5
Hard disk drive (HDD) / solid state disk (SSD)
142.
"Installing a 2.5-inch HDD/SSD module"
87.
Upgrade and Maintenance Manual
43.
44.
"Removing a 2.5-inch HDD/SSD
121.
Hardware: 10 minutes
45.
121.
"Handling
61.
"Performing a RAID
145