Hard disk drive (HDD) / solid state disk (SSD)
Figure 94: Connecting the cables (SAS/SATA variant)
▶ Connect the following cables to the HDD backplane:
1 SAS cable
2 OOB cable
3 Power cable
For the cable plan, see
Concluding steps
▶ Insert all HDD/SSD modules, see
on page
140.
Make sure that you reinstall the HDD/SSD module in the bay it was
located before the HDD backplane replacement.
▶ Insert all dummy modules, see
page
143.
▶
"Reassembling" on page
▶
"Connecting the power cord" on page
▶
"Switching on the server" on page
▶ If applicable,
"Installing the front cover with lock" on page
158
"Appendix B" on page
"Installing a 2.5-inch HDD/SSD module"
"Installing a 2.5-inch dummy module" on
53.
57.
60.
Upgrade and Maintenance Manual
363.
61.
RX1330 M5