Replacing The 4 X 2.5-Inch Hdd Backplane (Left Side) - Fujitsu PRIMERGY RX1330 M4 Upgrade And Maintenance Manual

Removing the defective 2.5-inch HDD/SSD module
▶ Remove the HDD/SSD module, see
module" on page
▶ If applicable, remove the HDD/SSD from the installation frame, see
"Handling HDDs or SSDs without installation frame" on page
Installing the new 2.5-inch HDD module
▶ If applicable, install the HDD/SSD in the installation frame, see
HDDs or SSDs without installation frame" on page
▶ Install the HDD/SSD module, see
on page 152.
Concluding steps
▶ If the HDD/SSD is configured using a RAID controller with a RAID level
higher than "0", the rebuild will start automatically, see
array rebuild" on page
7.5.5 Replacing the 4 x 2.5-inch HDD backplane (left
side)
Field Replaceable Unit
(FRU)
Tools: tool-less
Preliminary steps
▶
"Locating the defective server" on page
▶
"Shutting down the server" on page
▶
"Disconnecting the power cord" on page
▶
"Getting access to the component" on page
RX1330 M4
Hard disk drive (HDD) / solid state drive (SSD)
156.
"Installing 2.5-inch HDD/SSD modules"
87.
Upgrade and Maintenance Manual
"Removing a 2.5-inch HDD/SSD
135.
Hardware: 5 minutes
43.
45.
46.
48.
135.
"Handling
"Performing a RAID
159