Removing 3.5-Inch Hdd Modules - Fujitsu PRIMERGY RX1330 M5 Upgrade And Maintenance Manual

Figure 61: Installing the 3.5-inch HDD module
▶ Insert the HDD module into a drive bay and carefully push back as far as it
will go (1).
▶ Close the locking lever to lock the HDD module in place (2).
▶ When using a RAID array, add the additional HDD to the RAID array.
Configuring the RAID array, refer to the documentation of the RAID
controller, used in your configuration, see
on page
Concluding steps
▶ If applicable,
"Installing the front cover with lock" on page
7.4.3

Removing 3.5-inch HDD modules

Customer Replaceable
Unit (CRU)
Tools:
tool-less
Preliminary steps
▶ If applicable,
"Removing the front cover with lock" on page
▶ If the HDD module to be removed is combined into a RAID array, please
proceed as follows:
RX1330 M5
Hard disk drive (HDD) / solid state disk (SSD)
26.
Upgrade and Maintenance Manual
"Documentation overview"
61.
Hardware: 5 minutes
45.
129