Installing The Front Vga - Fujitsu PRIMERGY RX1330 M5 Upgrade And Maintenance Manual

Front panel
▶ Remove the two screws (see circles).
▶ Remove the front VGA cable from the cable clamp (A).
▶ Pull the front VGA connector out of the recess in the front VGA module.
▶ Thread the front VGA cable through the opening and remove it.
Installing the new front VGA
▶ Install the front VGA, see
▶ Install the front VGA module, see
page 267.
▶ Connect the front VGA cable, see
page 268.
Concluding steps
▶
"Installing the air duct" on page
▶
"Reassembling" on page
▶
"Connecting the power cord" on page
▶
"Switching on the server" on page
▶ If applicable,
"Installing the front cover with lock" on page
13.4.4

Installing the front VGA

Upgrade and Repair Unit
(URU)
Tools: – flat screw driver (for break out)
– hexagon screw driver 5 mm
270
"Installing the front VGA" on page
"Installing the front VGA module" on
"Connecting the front VGA cable" on
66.
53.
57.
60.
Upgrade and Maintenance Manual
266.
61.
Hardware: 5 minutes
RX1330 M5