Fujitsu PRIMERGY RX1330 M5 Upgrade And Maintenance Manual page 299

Tools: Removing the system board:
– Phillips PH2 / (+) No. 2 screw driver
Removing the TPM:
– Bit screw driver
– flat nose pliers
– TPM bit insert
(*)
For Japan:
– TPM module fixing tool (S26361-F3552-L909)
CAUTION
▶
Advise your contact persons that they must provide you with all
recovery keys which belong to the system to restore them in the
TPM later.
Preliminary steps
Preliminary steps are not necessary, if a system board has to be
replaced and the TPM is used again.
▶ Before removing the TPM board, remove the BitLocker protection and
decrypt the volume, see
volume" on page
▶ Disable the TPM in the system board BIOS, see
system board BIOS" on page
▶
"Suspending BitLocker functionality" on page
▶ If applicable,
"Removing the front cover with lock" on page
▶
"Shutting down the server" on page
▶
"Disconnecting the power cord" on page
▶ Remove all PSUs, see
▶
"Getting access to the component" on page
▶ Remove the air duct, see
RX1330 M5
(*)
"Removing BitLocker protection and decrypting the
300.
300.
"Removing a hot-plug PSU" on page
"Removing the air duct" on page
Upgrade and Maintenance Manual
System board and components
"Disabling the TPM in the
69.
46.
47.
49.
45.
105.
65.
299