Extron electronics XTP II CrossPoint 1600 User Manual page 25

XTP CP 4i DVI Pro (DVI Pro Input board) — See figure 10.
IN
8 8 8 8
Figure 10. DVI Pro Input Board Connectors
NOTE: Although the DVI Pro boards use DVI-I connectors, the switchers handle
only DVI-D (digital) video.
Input connectors — Connect a DVI cable between this port and the DVI
8
output port of the digital video source (see
assignments).
Audio Inputs (analog audio) connectors — Connect balanced or
7
unbalanced stereo audio inputs to these 3.5 mm, 5-pole captive screw
connectors (see Analog audio input connectors
the connectors).
XTP CP 4i 3G (3G/HD-SDI/SDI Input board) — See figure 11.
IN
INPUT LOOP OUT INPUT
9 9 ¢ ¢ 9 9
Figure 11. 3G Input Board Connectors
Input connectors — Connect a 3G-SDI, HD-SDI, or SDI video
9
input to this BNC connector. The board also accepts embedded
digital audio on this port.
Loop Out connector — Connect a local digital display to this
¢
BNC connector for a buffered loop-through of the input signal.
NOTE: The board ships with 75-ohm terminators on the Loop Out connectors.
Extron recommends leaving these installed when the loop out is not used.
Audio Inputs (analog audio) connectors — Connect balanced or
7
unbalanced stereo audio inputs to these 3.5 mm, 5-pole captive screw
connectors (see Analog audio input connectors
the connectors).
XTP CP 4i VGA (VGA Input board) — See figure 12.
IN
£ £ £ £
Figure 12. VGA Input Board Connectors
Input connectors — Connect a VGA cable between this port and the analog
£
video output port of the digital video source (see
page 24 for pin assignments and non-RGB video formats).
Audio Inputs (analog audio) connectors — Connect balanced or
7
unbalanced stereo audio inputs to these 3.5 mm, 5-pole captive screw
connectors (see Analog audio input connectors
the connectors).
XTP II CrossPoint 1600, 3200, and 6400 Switchers • Installation
8 8 8 8
DVI connectors
LOOP OUT INPUT LOOP OUT INPUT LOOP OUT
¢ ¢ 9 9 ¢ ¢ 9 9 ¢ ¢
£ £ £ £
Analog video connectors
XTP CP 4i DVI Pro
AUDIO
L R L R L R L R
7 7
on page 24 for pin
on page 25 to wire
XTP CP 4i 3G-SDI
AUDIO
L R L R L R L R
7 7
INPUT LOOP OUT
on page 25 to wire
XTP CP 4i VGA
AUDIO
L R L R L R L R
7 7
on
on page 25 to wire
17