Extron electronics XTP II CrossPoint 1600 User Manual page 26

Output boards space —
B
NOTE: See figure 2
figure 5 on page 14.
Install output boards as desired in input slots 1 through 4 (XTP II CrossPoint 1600),
slots 1 through 8 (XTP II CrossPoint 3200), or slots 1 through 16 (XTP II CrossPoint 6400)
and make connections. See
on page 145 and the individual board descriptions below.
NOTE: Install blank panels in unused locations to ensure proper ventilation.
XTP CP 4o (XTP Output board) — See figure 13.
1 1 3 3 1 1
OUT
SIG LINK SIG
PWR PWR
XTP LAN XTP
ACT LINK
2 2 2 2
Figure 13. XTP Output Board Connectors and Indicators
ATTENTION:
• The XTP output board can provide power over XTP (PoX) to connected
devices. PoX is intended for indoors use only. No part of a network that uses
PoX can be routed outdoors.
• La carte sortie XTP peut fournir l'alimentation sur XTP (PoX) aux appareils
connectés. PoX est destiné à une utilisation en intérieur uniquement. Aucune
partie d'un réseau qui utilise PoX ne peut être routée en extérieur.
NOTE: PoX must be enabled using:
• SIS commands (see the applicable
• Built-in HMTL pages (see
• The XTP System Configuration software (see the XTP System Configuration
Software help file, available at www.extron.com)
XTP output connectors — Connect an STP cable between this connector and
1
a compatible Extron XTP receiver (see
connector).
XTP Power indicators — Lights to indicate that the output board is providing
2
power over XTP (PoX) to the receiver connected to this RJ-45 connector.
LAN (Ethernet) connectors — As desired, connect a TP cable between a
3
host device or control LAN and this connector for passive extension to the LAN
(Ethernet) connector on the connected endpoint (see
to wire the connector).
IR/RS-232 Over XTP Connectors — If desired, connect serial RS-232 signals,
4
modulated IR signals, or both to these 3.5 mm, 5-pole captive screw connectors
for bidirectional RS-232 and IR communications on the associated outputs (see
RS-232 and IR connectors
XTP II CrossPoint 1600, 3200, and 6400 Switchers • Installation
on page 11, figure 3 on page 12,
Installing the Input or Output Board or Blank Panel
3 3 1 1 3 3 1 1
LINK SIG LINK SIG LINK
PWR PWR
LAN XTP LAN XTP
ACT LINK ACT LINK
2 2 2 2
XTP Power
XTP Power Page, on page 141)
TP connectors
on page 23 to wire the connectors).
figure 4 on page 13, and
3 3
IR/RS-232 OVER XTP
RS-232 IR RS-232 IR RS-232 IR RS-232
LAN
ACT LINK Tx Rx G Tx Rx Tx Rx G Tx Rx Tx Rx G Tx Rx Tx Rx
4 4
SIS commands on page 92)
on page 21 to wire the
TP connectors on page 21
XTP CP 4o
IR
G Tx Rx
18