Performing A System Reset From The Front Panel - Extron electronics XTP II CrossPoint 1600 User Manual

Selecting Lock mode 2 or toggling between mode 2 and mode 1
NOTE: If the switcher is in Lock mode 0 or mode 1, this procedure selects mode 2.
Toggle the lock on and off by pressing and holding the
simultaneously for approximately 2 seconds (see figure 48).
Lock mode 1
C O N T R O L
ENTER
PRESET VIEW
Press and hold for
2 seconds.
Figure 48.

Performing a System Reset from the Front Panel

The front panel reset is identical to issuing the E ZXXX } SIS command defined on
page 111. A system reset performs the following functions:
NOTES:
• System reset does not reset the Internet protocol (IP) settings or replace
user-installed firmware.
• This function resets not only the switcher, but any connected endpoints.
• Clears all ties and presets
• Clears all mutes
• Disables all RS-232 output inserts
• Resets all input audio levels to unity gain (0 dB)
• Sets all output volume levels to 100% (0 dB of attenuation)
Reset the switcher to the factory default settings by pressing and holding the
and button simultaneously while you apply AC power to the switcher (see figure 49).
Esc
The switcher flashes
the button indicators
and then turns them off.
Figure 49.
NOTE: If background illumination was turned on before the reset, all buttons are unlit
after the reset. But, when you cycle power, background illumination returns to the
condition that you previously selected.
If the switcher is in Lock mode 2, this procedure selects mode 1.
C O N T R O L
ESC ENTER PRESET VIEW ESC
Toggle Front Panel Lock Between Mode 2 and Mode 1
Press and hold the buttons
simultaneously while you
apply power to the switcher.
CONTROL
VIEW ESC
Continue to hold the View and Esc
buttons until all input and output buttons
return to unlit and the Video and Audio
buttons light.
Release the buttons.
System Reset
XTP II CrossPoint 1600, 3200, and 6400 Switchers • Operation
button and the
Vies
Lock mode 2
C O N T R O L
ENTER
ENTER
PRESET VIEW ESC
Press and hold for
2 seconds.
Power
button
Esc
C O N T R O L
PRESET VIEW ESC
button
View
63