Removing And Installing A Power Supply Assembly (Xtp Ii Crosspoint 6400); Removing A Power Supply Assembly; Installing A Power Supply Assembly - Extron electronics XTP II CrossPoint 1600 User Manual

Removing and Installing a Power Supply Assembly
(XTP II CrossPoint 6400)
The XTP II CrossPoint 6400 has four field replaceable, hot-swappable power supply
assemblies: primary and redundant 12 V and primary and redundant 48 V.

Removing a Power Supply Assembly

Remove a power supply assembly as follows:
1.
2.
3.
4.

Installing a Power Supply Assembly

Install a power supply assembly as follows:
1.
2.
3.
4.
Open the power supply cabinet as follows:
a. Turn the door fastener clockwise from
b. Swing the door open.
Use an Extron Tweeker or small screwdriver to remove the locking screw (see figure 77,
).
1
Figure 77. Removing a Power Supply Assembly
Slide the power assembly to the right (
If you are not going to install a replacement power supply immediately, close the power
supply cabinet door and turn the door fastener counter-clockwise to lock it shut.
If necessary, open the power supply cabinet in accordance with "Removing a Power
Supply Assembly," step 1.
Orient the power supply to be installed so that the voltage label is facing you and right-
side up.
NOTE: The power supply assemblies are keyed so that you cannot install a power
supply assembly of the wrong voltage.
Place the power supply assembly on the shelf in the power supply cabinet, against the
right wall. Slide the power supply assembly fully into the cabinet, so that it contacts the
back wall.
Slide the power supply to the left until it contacts the left wall.
XTP II CrossPoint 1600, 3200, and 6400 Switchers • Maintenance and Modifications
to .
) and pull the assembly from the cabinet.
2
146