Extron electronics XTP II CrossPoint 1600 User Manual page 69

4. Change the volume: Press and release the
increase the volume by 1.5%.
Press and release the
Esc
volume by 1.5% per button press. Note the input button indication changes that occur
each time the ( ) button is pressed and released.
>
Esc
NOTE: You can press and hold the
or down by 3 dB per second to the high or low limit.
Figure 45 shows the result of pressing the
figure 45 and figure 46, the lit or blinking input buttons indicate 61 percent of the applied
audio input. The unlit input buttons indicate an audio volume attenuation of 26 dB.
Press the button
ESC
Decrease the audio
attenuation (thereby
increasing the audio level)
that is applied to the
output volume level by
1 dB per button push.
Each lit input button beyond input 1 indicates that 3 percent of the total input is applied to the output.
Figure 45. Adjust the Output Audio Volume
Figure 46 shows the same volume (61%) as in figure 45, but displayed on an
XTP II CrossPoint 1600 switcher.
1 2 3 4 5
Figure 46. Volume Display on an XTP II CrossPoint 1600 Switcher
5. Exit Audio mode: Press and release the
Press the button.
The Video button
VIDEO
lights green.
All input buttons and output buttons
return to unlit or background illumination.
XTP II CrossPoint 1600, 3200, and 6400 Switchers • Operation
(
Esc
( ) button several more times (figure 45) to increase the
>
( ) or
>
Esc View
( ) button a total of 13 times. In
Esc >
INPUTS
1 2 3 1 12 13 14 15 16
17 18 19 27 28 29 30 31 32
26 dB attenuation,
61% volume
26 dB attenuation
61% volume
INPUTS
6 7
8 9 10 11 12
button.
Audio
I / O
The Audio button stops
AUDIO
blinking and lights.
) button once (see figure 45) to
>
( ) button to ramp the level up
>
13 14 15 16
61