Plugging In The Printer - Intermec EasyCoder PD42 User Manual

Chapter 2 — Installing the Printer

Plugging in the Printer

22
5 "Ink in" ribbon only: route the ribbon and set the ink
position lever as indicated below.
6 Load media in the printer, if you have not already done so.
7 Restart the printer and print test labels (See
Labels" on page 23).
1 Make sure the Power switch is turned off.
2 Connect the power cable to the printer.
3 Plug the power cable into your electrical outlet.
"Printing Test
EasyCoder PD42 Printer User's Guide