Plugging In The Printer - Intermec EasyCoder 3240 Getting Started Manual

EasyCoder 3240 Printer Getting Started Guide

Plugging In the Printer

1-6
The back of the 3240 printer contains the AC power cord receptacle, the serial
communications port, the On/Off (|/O) switch, and two banks of DIP
switches.
To plug in the printer
1. Turn the On/Off switch to the off (O) position.
2. Make sure you set the DIP switches to their factory default settings.
Set switch 1 on. Set switches 2 through 8 off.
Top Bank
Set switches 1 through 8 off.
Bottom Bank
3. Plug the AC power cord into the receptacle at the rear of the printer.
4. Plug the other end of the power cord into a grounded wall outlet or surge
protector.
5. Turn the On/Off switch to the on (|) position. When you power on the
printer, the green LED lights, the yellow LED flashes, and the platen roller
advances. The yellow LED then stays on until you load media.
DIP
switches
Serial
communications
port
On/Off
O
switch
AC power cord
receptacle
3240G.003