Network Setup; Returning To Factory Default Setup - Intermec EasyCoder PD42 User Manual

Network Setup

Returning to Factory Default Setup

EasyCoder PD42 Printer User's Guide
Cutter (option)
Once a cutter has been installed in the printer, it must also be
enabled in the firmware. IPL commands are used to enable/
disable the cutter in configuration mode:
<STX>R<ETX>
<STX><SI>c1<ETX>
<STX><SI>c0<ETX>
Please refer to the EasyLAN User's Guide (P/N 1-960590-xx) for
information on the network setup parameters.
You can restore all the printer's default settings in Extended
testmode (see page 36), or by using the Factory Default Wizard
in PrintSet 4.
Appendix D — Setup Parameters (IPL)
Enter print/configuration mode
Enable cutter
Disable cutter
113