Intermec EasyCoder PD42 User Manual page 38

Chapter 3 — Configuring the Printer
28
The behavior of the green Data/Ready LED and red Error LED
in various states is shown in the table below.
Ready/Data and Error LED Behavior
State
Power Off
Upgrading
Testmode
Extended Testmode
PUP
Idle
Application running
Printing
Printing (wait for LTS) Quick flashes
Paused
Error
Footnotes:
1 Flashing with 50% duty cycle, 0.8 second period when receiving
data, synchronized with Ready-to-Work LED.
2 Two fast flashes, 1.6 second period.
3 Flashing with 50% duty cycle, 0.8 second period, not synchronized
with Ready-to-Work LED.
4 Error LED will be lit for these conditions: Out of Paper, Out of
Ribbon, Head Lifted, Cutter Error, and Testfeed not Done. Will
flash as (2), when thermal printhead is too hot. Will flash as (3) for
other error conditions caught by the Direct Protocol error handler.
Ready/Data LED
Off
LEDs turned on one after the other.
See Chapter 5 for description.
See Chapter 5 for description.
On
1
On/Flash
On
1
On/Flash
2
3
Flash
Off
EasyCoder PD42 Printer User's Guide
Error LED
Off
Off
Off
Off
Off
Off
Off
4
On / Flash