Chapter 3 — Configuring the Printer
Running Testmode and Extended Testmode
Running Testmode
34
The corresponding instruction in IPL is:
<STX><SI>T1<ETX>
Note: IPL users should first verify that they have the
correct HyperTerminal settings. See the screen capture
below.
Hyperterminal settings (IPL only)
For more information on how to change setup parameters, see
the Fingerprint Programmer's Reference Manual (P/N 937-005-
xxx), or the IPL Programmer's Reference Manual (P/N 066396-
xxx).
Use Testmode and Extended testmode when you want to verify
printer settings, print test labels, restore factory default settings,
or enter Dumpmode for troubleshooting purposes. Two
testmodes are available, Testmode and Extended Testmode.
Testmode is a simple linear sequence which requires little input,
while Extended Testmode gives the user more options.
Testmode performs the following sequence:
1 Select media type (gaps/mark/continuous).
EasyCoder PD42 Printer User's Guide