Intermec EasyCoder PD42 User Manual page 62

Intermec easycoder pd42: user guide
Hide thumbs Also See for EasyCoder PD42:
Table of Contents

Advertisement

Chapter 4 — Troubleshooting and Maintaining the Printer
52
To adjust printhead dot line
1 Open the side door.
2 Remove the ribbon and engage the printhead.
3 Use a straight-slot screwdriver to turn the two screws at the
top of the printhead bracket counterclockwise a single turn.
4 Lift the printhead by pulling the printhead lever and flipping
it counterclockwise a quarter of a turn.
5 Carefully turn both screws at the front of the printhead
clockwise a quarter of a turn at a time (a full turn
corresponds to 0.55 mm, which is a lot). Make sure to make
identical adjustments on both screws. If you are unsure,
tighten both screws completely by turning them
counterclockwise as far as they go and start over.
6 Engage the printhead and lock it by tightening the two screws
at the top of the printhead bracket, that is, the reverse action
of Step 3.
EasyCoder PD42 Printer User's Guide

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents