Printing Test Labels - Intermec EasyCoder PD42 User Manual

Printing Test Labels

EasyCoder PD42 Printer User's Guide
In order to verify that the printer is fully functional and to obtain
its current configuration, you can print test labels for the various
printer functions (for instance ,hardware and software
configuration).
To print a set of test labels from startup
1 Make sure the printer is turned off.
2 Load media as described in
3 Press and hold the blue Print button.
4 Keep the Print button pressed down, and turn on the power
switch. After approximately ten seconds the printer enters
Testmode and three of the front LEDs start flashing one at a
time.
The display window lights up, and the printer runs a media
setup routine.
5 Continue to press the Print button until the printer starts
cycling through the selectable media types (Gap/Mark/
Continuous). For help, see Appendix B,
Specifications."
6 Select your media type by releasing the Print button at the
appropriate time.
SELECT MEDIA
GAP
The printer will print several test labels containing the
printer's setup parameters. It will then enter Dumpmode.
Chapter 2 — Installing the Printer
"Loading Media" on page
SELECT MEDIA
MARK
SELECT MEDIA
CONTINUOUS
14.
"Media
23