6
The New Project Window is
displayed.
This window consists of the
following panes.
Left: Multiview Explorer
Upper right: Toolbox
Lower right: Controller Status
Pane
Top middle: Edit Pane
In the lower center of the
window, the tabs for the
following tab pages are
displayed.
Output Tab Page
Build Tab Page
7
Double-click Built-in
EtherNet/IP Port Settings
under Configurations and
Setup – Controller Setup in
the Multiview Explorer.
8
The Built-in EtherNet/IP Port
Settings Tab Page is displayed
in the Edit Pane.
In IP Address, set the following
information.
IP address: 192.168.188.200
Subnet mask:
255.255.0.0
7. EtherNet/IP Connection Procedure
Multiview
Edit Pane
Explorer
Output Tab
Build Tab
Page
Page
Toolbox
Controller
Status Pane
26