Yamaha DRCX User Manual page 75

4-5 Restricting Key Operation by Access Level
4
10
4-
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
5) Select the item you want to change.
To change the access level for editing, press
(EDIT).
F1
To change the access level for operation, press
(OPRT).
F2
To change the access level for system-related
data, press (SYS).
F3
To change the access level for memory card,
press (CARD).
F4
6) The currently set access level appears.
To change this setting, use the number key to
enter the access level and then press
7) When the access level has been changed, the
memory write screen appears.
To save the change permanently (retain the
change even after the controller power is turned
off), press (SAVE).
F1
To save the change temporarily (retain the
change until the power is turned off), press
(CHG).
F2
To cancel changing of the setting, press
(CANCEL).
F3
8) When writing is complete, the screen returns
to step 6.
n
NOTE
The password is identical to the DRCX controller's version number. For example, if the controller version is 18.11,
enter 18.11 as the password. Once the password is accepted, it will not be requested unless the TPB is disconnected
from the controller or the controller power is turned off.
n
NOTE
To avoid access level conflict between operation and others, the access levels may be automatically adjusted. For
example, if the access levels related to editing, system and memory card are "0", they are automatically changed to
"1" when the operation-related access level is "1" or "2" or "3". The access levels remain unchanged if they are "1"
or "2" or "3".
[SYS-SAFE-ACLV]
select menu
1EDIT2OPRT3SYS 4CARD
[SYS-SAFE-ACLV-EDIT]
.
access level : 0
all access OK
[SYS-SAFE-ACLV-EDIT]
access level : 1
change PGM invalid
1SAVE2CHG 3CANCEL
[SYS-SAFE-ACLV-EDIT]
access level : 1
change PGM invalid