Initializing The Scalance X204Rna Eec (Prp/Hsr) - Siemens SIMATIC NET SCALANCE X-200RNA Operating Instructions Manual

Functional description and configuration using Web Based Management

9.4 Initializing the SCALANCE X204RNA EEC (PRP/HSR)

9.4 Initializing the SCALANCE X204RNA EEC (PRP/HSR)
Status as shipped
The SCALANCE X204RNA EEC (PRP/HSR) is always in the uninitialized status if it still has the
factory settings. You can return the device to the factory settings using the SELECT/SET button
(see section "SELECT/SET button (Page 49)"), using WBM and the CLI.
Initializing with WBM
You can initialize the SCALANCE X204RNA EEC (PRP/HSR) using WBM. When doing this, you can
specify whether the device will be operated in the "PRP" or "HSR" mode using the "Set PRP Mode
and Restart" and "Set HSR Mode and Restart" buttons. The device is then restarted and is in the
selected operating mode.
Figure 9-2
Initializing with CLI
You can also initialize the SCALANCE X204RNA EEC (PRP/HSR) using the CLI command "setmode
[PRP|HSR]".
/
..
?
exit
restart
setmode [PRP|HSR]
info
SYSTEM
X-200
AGENT
SWITCH
88
Initializing the SCALANCE X204RNA EEC (PRP/HSR) using WBM
(Go to top of menu tree)
(Go up in menu tree)
(Show menus/commands)
(Exit from CLI/TELNET session)
(Shutdown and startup again)
(Set PRP-/HSR mode and restart)
(Show identification data)
(Open SYSTEM menu)
(Open X-200 menu)
(Open AGENT menu)
(Open SWITCH menu)
Operating Instructions, 04/2022, C79000-G8976-C342-07
SCALANCE X-200RNA