SHOCK ABSORBER, SWINGARM
9
9.17
Changing the ilot bushing
-
Remove washer
-
Remove washer
-
Remove dust boot.
201407-10
Preparatory work
-
Remove the spring. (.- p. 48)
-
Disassemble the damper. (.- p. 49)
-
Disassemble the piston rod. (.- p. 50)
-
Disassemble the seal ring retainer. (.- p. 51)
Main work
-
Press pilot bushing
I
Press drift (T1504) (.- p. 269)
-
Slide the new pilot bushing
I
Press drift (T1504) (.- p. 269)
Position the pilot bushing in the seal ring retainer using the special tool.
I
Press drift (T1504) (.- p. 269)
-
Support seal ring retainer
bushing all the way in.
I
Assembly tool (T150S) (.- p. 269)
-
Lubricate the special tool.
Shock absorber fluid (SAE 2.5) (50180751 S1) (.- p. 256)
Calibration pin (T1205) (.- p. 267)
-
Support seal ring retainer
I
Assembly tool (T150S) (.- p. 269)
-
Press the special tool through the new pilot bushing.
I
Calibration pin (T1205) (.- p. 267)
✓ The pilot bushing is calibrated.
Finishing work
-
Assemble the seal ring retainer. (.- p. 55)
0.
(D
for seal ring
@.
O
out of seal ring retainer
O
onto the special tool.
fj
with sleeve 6) of the special tool. Press the pilot
fj
with sleeve 6) of the special tool.
fj
with the special tool.
52