Removing The Front Brake Disc; Installing The Front Brake Disc; Changing The Front Wheel Bearing - Husqvarna FE 350 2014 Repair Manual

WHEELS
14
14.5.3

Removing the front brake disc

14.5.4

Installing the front brake disc

14.5.5

Changing the front wheel bearing

-
Lift the front wheel into the fork, position it, and insert the wheel spindle.
✓ The brake linings are positioned.
-
Mount and tighten screw
Guideline
I
Screw, front wheel spindle
-
Activate the hand brake lever multiple times until the brake linings are in contact
with the brake disc.
-
Remove the motorcycle from the lift stand. (,r- p. 11)
-
Pull the front wheel brake and push down hard on the fork several times to align
the fork legs.
-
Tighten screws (D.
Guideline
I
Screw, fork stub
Preparatory work
-
Raise the motorcycle with a lift stand. (,r- p. 11)
-
Remove the front wheel. (,r- p. 88)
Main work
0-
-
Remove screws Take off the brake disc.
Main work
-
Clean the contact surface of the brake disc.
-
Position the brake disc with the label facing outward. Mount and tighten
O.
screws
Guideline
Screw, front brake disc
Finishing work
-
Install the front wheel. (,r- p. 88)
Preparatory work
-
Raise the motorcycle with a lift stand. (,r- p. 11)
-
Remove the front wheel. (,r- p. 88)
Main work
-
Remove shaft seal rings
8.
I
M24x1.5
M6 14 Nm
(10.3 lbf ft)
O 8.
and
89
I I
45 Nm (33.2 lbf ft)
I
I1s Nm (11.1 lbf ft)
Loctite ® 243
™