Clutch; Checking/Rectifying The Fluid Level Of The Hydraulic Clutch; Changing The Hydraulic Clutch Fluid - Husqvarna FE 350 2014 Repair Manual

19

CLUTCH

Checkin
Info
The fluid level rises with increased wear of the clutch lining discs.
19.2

Changing the hydraulic clutch fluid

Warning
Environmental hazard
-
Oil, grease, filters, fuel, cleaners, brake fluid, etc., should be disposed of as stipulated in applicable regulations.
ing the fluid level of the h draulic clutch
-
Move the clutch fluid reservoir mounted on the handlebar to a horizontal position.
-
Remove screws
-
Remove cover
-
Check the fluid level.
I
Fluid level below container rim
If the fluid level does not meet specifications:
-
Correct the fluid level of the hydraulic clutch.
I Brake fluid DOT 4 (,... p. 256)
-
Position the cover with the membrane. Mount and tighten the screws.
Info
Clean up overflowed or spilt brake fluid immediately with water.
Hazardous substances cause environmental damage.
-
Move the clutch fluid reservoir mounted on the handlebar to a horizontal position.
-
Remove screws
-
Remove cover
-
Fill bleeding syringe
Bleed syringe (50329050000) (,... p. 259)
Brake fluid DOT 4 (,... p. 256)
e.
On the clutch slave cylinder, remove bleeder screw
syringe
-
Inject the liquid into the system until it escapes from openings
cylinder without bubbles.
-
To prevent overflow, drain fluid occasionally from the master cylinder reservoir.
-
Remove the bleeding syringe. Mount and tighten the bleeder screw.
-
Correct the fluid level of the hydraulic clutch.
Guideline
Fluid level below top edge of con­
tainer
-
Position the cover with the membrane. Mount and tighten the screws.
O.
8 CD.
with membrane
I
4 mm (0.16 in)
O.
8 CD.
with membrane
8
with the appropriate hydraulic fluid.
4 mm (0.16 in)
187
0
and mount bleeding
0)
of the master