Husqvarna FE 350 2014 Repair Manual page 107

16
BRAKE SYSTEM
r-----
-
Move the brake fluid reservoir mounted on the handlebar to a horizontal position.
-
Remove screws
-
Remove cover
-
Manually press the brake caliper to the brake disc to push back the brake
pistons. Ensure that brake fluid does not flow out of the brake fluid reservoir,
extracting it by suction if it does.
• Info
I
Make sure when pushing back the brake pistons that you do not press the
brake caliper against the spokes.
-
Remove cotter pins
-
Clean the brake caliper and brake caliper support.
-
Check that leaf spring
caliper support are seated correctly.
-
Insert the new brake linings, insert pin
• Info
I
Always change the brake linings in pairs.
-
Operate the hand brake lever repeatedly until the brake linings are in contact with
the brake disc and there is a pressure point.
-
Correct the brake fluid to level fj.
Guideline
Level fj (brake fluid level below con-
tainer rim)
I
Brake fluid DOT 4 (� p. 256)
-
Position cover
-
Mount and tighten screws
Info
Clean up overflowed or spilt brake fluid immediately with water.
M00411-10
O.
8
with membrane@).
8, 0,
pull out pin and remove the brake linings.
(D
in the brake caliper and sliding plate @ in the brake
0,
and mount cotter pins
5 mm (0.2 in)
8
with membrane @).
O.
105
8.