Motorcycle; Raising The Motorcycle With A Lift Stand; Removing The Motorcycle From The Lift Stand; Starting - Husqvarna FE 350 2014 Repair Manual

5

MOTORCYCLE

5.1 Raising the motorc cle with a lift stand
5.2 Removin the motorc cle from the lift stand
Note
Danger of damage The parked vehicle may roll away or fall over.
-
Always place the vehicle on a firm and even surface.
5.3

Starting

Danger
Danger of poisoning
-
When running the engine, always make sure there is sufficient ventilation, and do not start or run the engine in an
enclosed space without an effective exhaust extraction system.
Note
Engine failure High engine speeds in cold engines have a negative effect on the service life of the engine.
-
Always warm up the engine at low engine speeds.
Note
Danger of damage
-
Always place the vehicle on a firm and even surface.
-
Raise the motorcycle at the frame underneath the engine.
I
Lift stand (81329955000) (,... p. 266)
✓ Neither wheel is in contact with the ground.
-
Secure the motorcycle against falling over.
401942-01
-
Remove the motorcycle from the lift stand.
-
Remove the lift stand.
-
To park the motorcycle, press side stand
lean the motorcycle on it.
• Info
I
When you are riding, the side stand must be folded up and secured with
the rubber band.
401943-10
Exhaust gases are toxic and inhaling them may result in unconsciousness and/or death.
-
Raise the motorcycle off of the stand and secure the stand with the rubber
0-
band
-
Shift transmission to neutral.
(FE 350 AU)
-
Turn the emergency OFF switch to the position 0.
Condition
Ambient temperature: < 20 °C (< 68 °F)
-
Pull the idle speed adjusting screw all the way out.
401944-11
-
Press the electric starter button.
• Info
I
Press the electric starter button for at most 5 seconds. Wait for a least 5
seconds before trying again.
Warning lamp Fl lights up briefly as a functional control when starting.
400733-01
The parked vehicle may roll away or fall over.
O
to the ground with your foot and
11