Husqvarna FE 350 2014 Repair Manual page 20

6
FORK, TRIPLE CLAMP
-
Unclamp the fork leg.
-
Push the outer tube down. Drain the fork oil.
-
Clamp the fork leg with the axle clamp.
0
-
Release hydrostop unit
• Info
I
Do not use an impact wrench.
Place a pan underneath since oil will run out.
-
Remove the cartridge from the fork leg.
I
Press-out tool (T1 4051) (- p. 269)
• Info
I
Removing the O-ring seat from the cartridge usually requires the applica­
tion of force.
0.
-
Remove dust boot
-
Remove fork protection ring f).
• Info
I
The fork protection ring does not necessarily need to be removed for
repair work.
-
Remove lock ring @.
• Info
I
The lock ring has a ground end against which a screwdriver can be posi­
tioned.
-
Warm the outer tube in area C5) of the lower sliding bushing.
I Guideline
so c
(122 °F)
0
-
Pull the outer tube forcefully off of the inner tube.
Info
The lower sliding bushing
and remove it.
@)
must be pulled out of its bearing seat.
18