Checking The Starter Relay - Husqvarna FC 250 2018 Repair Manual

15.10
Checking the starter rela�
Preparatory work
-
Press and hold the kill switch Q9 while the engine is idling until
the engine stops.
-
Remove the air filter box cover.
-
Remove the seat.
-
Disconnect the negative cable of the 12 V battery.
Main work
-
Pull starter relay
-
Unplug connector
-
Pull back the cover.
-
Disconnect cable
m
-
Connect the starter relay to a 12 V power supply as per the
figure.
-
Measure the resistance between the specified points.
I
Resistance of open circuit
If the value displayed does not meet specifications:
-
Change the starter relay.
-
Clamp cable
-
Plug in connector
-
Mount the starter relay onto the holder and route the cable.
Finishing work
-
Connect the negative cable of the 12 V battery.
-
Mount the seat.
-
Install the air filter box cover.
WIRING HARNESS, BATTERY 15
(ra!l p. 95)
(ra!l p. 99)
O
from the holder.
8.
8
from the starter relay.
I
O Q
8
on the starter relay.
8.
(ra!l p. 100)
(ra!l p. 95)
(0 p. 135)
(0 p. 135)
..
141