Table of Contents
Advertisement
17 ENGINE
17.4.33
-
Check clutch throw-out
-
Check axial bearing
-
Place the clutch push rod
-
Check the length of clutch springs
I
Clutch spring - length
-
Check the contact surface of clutch pressure cap
-
Check clutch basket
-
Check needle bearing @ and collar sleeve
-
Check intermediate clutch discs
-
Check clutch facing discs � for discoloration and scoring.
218
Checking the clutch
•-
O
for damage and wear.
If
there is damage or wear:
-
Change the clutch push rod.
8
for damage and wear.
If
there is damage or wear:
-
Change the axial bearing.
(D
on a flat surface and check for run-out.
there is run-out:
If
-
Change the clutch push rod.
the clutch spring length is shorter than specified:
If
-
Change all clutch springs.
there is damage or wear:
If
-
Change the clutch pressure cap.
(D
for damage and wear.
there is damage or wear:
If
-
Change the clutch basket.
there is damage or wear:
If
-
Change the needle bearing and collar sleeve.
the intermediate clutch discs are not level and are pitted:
If
-
Change all intermediate clutch discs.
there is discoloration or scoring:
If
-
Change all clutch facing discs.
C,.
I�
38.5 mm(� 1.516 in)
0
for damage and wear.
C)
for damage and wear.
«D
@)
and
for damage and wear.
-•
310351-10
Advertisement
Table of Contents
