Husqvarna FC 250 2018 Repair Manual page 200

17 ENGINE
198
Press out bearing
B03752-10
Mount lock ring
Press the shaft seal ring
the outside with the open side facing in.
Press the new bearing
outside using a suitable tool.
B03752-10
Press in shaft seal ring
facing outward.
Remove lock ring
Remove shaft seal ring
Press the new shaft seal ring in with the open side facing
inward.
Info
Press the shaft seal ring inward to the point where the
lock ring can be mounted.
Provide suitable support for the clutch cover while
B03753-10
pressing in.
Mount lock ring
Blow out the oil channel with compressed air and check that
it is clear.
C,
toward the inside.
8-
(D
all the way in from the inside to
C,
all the way in from the inside to the
O
all the way, with the open side
0.
(D
of the crankshaft.
0.