Table of Contents
Advertisement
16 BRAKE SYSTEM
Warning
-
152
,r-----309386-10
Checking the brake linings of the rear brake
Danger of accidents
Worn-out brake linings reduce the braking effect.
Ensure that worn-out brake linings are replaced immediately.
0
-
Pull off protection cap
screw. Connect the bleeder bottle hose.
I
Bleeding device (00029013100)
(D
Open bleeder screw
Info
Drain until fresh brake fluid emerges in the bleeder
bottle hose without bubbles.
-
Tighten the bleeder screw.
8.
-
Close shut-off valve
-
Open the bleeder screw again until brake fluid stops
emerging.
•
Info
I
Overfilling the brake fluid reservoir is prevented.
-
Tighten the bleeder screw. Remove the bleeder bottle
hose. Attach the protection cap.
-
Disconnect the bleeding device. Remove the bleeder
cover.
-
Add brake fluid up to level (9 .
Guideline
Level (9 (brake fluid level
below reservoir rim)
I
Brake fluid DOT 4 / DOT 5.1
-
Position the cover with the membrane. Mount and tighten
the screws.
Info
Clean up overflowed or spilled brake fluid immedi
ately with water.
-
Check the hand brake lever for a firm pressure point.
of the brake caliper bleeder
(!el
p. 303)
by approx. one half turn.
5 mm (0.2 in)
(!el
p. 298)
Advertisement
Table of Contents
