Table of Contents
Advertisement
-
@.
Mount bleeder cover
I Bleeder cover (00029013006)
-
Connect the bleeding device.
I Bleeding device (00029013100)
@).
-
Open shut-off valve
•
Info
I
Follow the instructions in the Owner's Manual of
the bleeding device.
-
Ensure that the filling pressure is set on pressure
gauge 6). Correct the filling pressure on pressure
regulator G) if necessary.
Guideline
I Filling pressure
C,
-
Pull off protection cap
the bleeder bottle hose.
I Bleeding device (00029013100)
0
Open bleeder screw
•
Info
I
Drain until fresh brake fluid emerges in the bleeder
bottle hose without bubbles.
-
Tighten the bleeder screw.
@).
-
Close shut-off valve
-
Open the bleeder screw again until brake fluid stops
emerging.
•
Info
I
Overfilling the brake fluid reservoir is prevented.
-
Tighten the bleeder screw. Remove the bleeder bottle
hose. Attach the protection cap.
-
Disconnect the bleeding device. Remove the bleeder
cover.
-
Stand the vehicle upright.
-
Correct the brake fluid to marking
I Brake fluid DOT 4 / DOT 5.1
-
Mount and tighten the screw cap with the membrane and
O-ring.
•
Info
I
Clean up overflowed or spilled brake fluid immedi
ately with water.
BRAKE SYSTEM 16
(0
p. 302)
(0
p. 303)
I 2 ... 2.5 bar (29 ... 36 psi) I
of the bleeder screw. Connect
(0
p. 303)
by approx. one half turn.
(!).
(0
p. 298)
161
Advertisement
Table of Contents
