Table of Contents
Advertisement
-
Add brake fluid to level f).
I Brake fluid DOT 4 / DOT 5.1
-
Mount and tighten screw cap
the O-ring.
Info
Clean up overflowed or spilled brake fluid immedi
ately with water.
(Option: MAGURA)
-
Stand the vehicle upright.
-
Remove the cable tie on the frame protector.
O
-
Remove screw cap
-
Manually press the brake caliper toward the brake disc
to push back the brake piston. Ensure that brake fluid
does not flow out of the brake fluid reservoir, if necessary
extract excess.
Info
Make sure that you do not press the brake caliper
against the spokes when pushing back the brake
piston.
-
Remove cotter pin (D.
8
-
Push spring plate
-
Remove the brake linings.
-
Clean the brake caliper and brake caliper bracket.
-
Check that spring plate
(D
ing plate
in the brake caliper bracket are seated cor
rectly.
-
Insert the new brake linings.
0-
-
Mount pin
8
✓ Spring plate
Info
Always change the brake linings in pairs.
Make sure that decoupling plate @ is mounted
on the piston side brake lining.
-
Mount cotter pins (D.
BRAKE SYSTEM 16
(a
p. 298)
O
with membrane @ and
with membrane @ and the shim.
downwards and remove pin
8
in the brake caliper and slid-
engages in the groove on the pin.
0.
155
Advertisement
Table of Contents
