Emi/Cooling Shield - HP Compaq SP700 User Manual
Hp compaq sp700: user guide
Hide thumbs
Also See for Compaq SP700:
- Maintenance and service manual (8 pages) ,
- Reference manual (174 pages)
Table of Contents
Advertisement
3-8
Removal and Replacement Procedures
EMI/Cooling Shield
An EMI/cooling shield covers bays 5 and 6 to provide proper cooling and EMI protection. To
remove the EMI/cooling shield:
1.
Perform the service preparations on page 3-2.
2.
Remove the following components:
side access panel
front bezel
3.
Remove the two screws that connect the EMI/cooling shield to the front of the chassis.
4.
Remove the EMI/cooling shield from the drive slot.
Figure 3-7.
Removing the EMI/cooling shield
IMPORTANT: You will need to replace the shield after the drive is installed in the bay.
To replace the EMI/cooling shield, reverse the above procedure.
CO MP
ACT
Advertisement
Table of Contents
