3-34
Removal and Replacement Procedures
Installing a Hard Drive in the Removable Hard Drive
Cage
To install a hard drive in the removable hard drive cage:
1.
Perform the service preparations shown on page 3-2, remove the workstation feet, and
place the workstation on its side.
2.
Remove the following components:
side access panel
removable hard drive cage
3.
Remove four hard drive screws (top group of screws) from the side of the air plenum
located at the front of the workstation.
4.
Locate the correct screw holes for the hard drive you will be installing.
Figure 3-31. Locating the hard drive screw holes
4
3
2
1