HP Compaq SP700 User Manual page 14

3-14 Removal and Replacement Procedures
Removing PCI or ISA Expansion Boards
NOTE: The following procedure is also applicable for removing a PCI-based graphics controller.
IMPORTANT: Before replacing the I/O bracket assembly, read "Important Guidelines for I/O
Bracket Assembly Replacement" earlier in this chapter.
To remove an expansion board from a PCI or ISA expansion slot:
1. Perform the service preparations shown on page 3-2, remove the workstation feet, and
place the workstation on its side.
2. Remove the following components:
side access panel
I/O bracket assembly
3. Remove the retaining screw securing the expansion board.
4. Hold the expansion board at each end and carefully rock it back and forth until the
connectors pull free from the slot.
Figure 3-11.
To replace an expansion board, reverse the above procedure.
NOTE: Be sure to engage the card guide located behind the fan when replacing a full-length
expansion board.
IMPORTANT: Before replacing the I/O bracket assembly, read "Important Guidelines for I/O
Bracket Assembly Replacement" earlier in this chapter.
CAUTION: If you permanently remove an expansion board, install a protective slot
cover to ensure proper cooling.
Removing a PCI-based graphics controller