HP Compaq SP700 User Manual page 46

3-46 Removal and Replacement Procedures
Removing a DIMM
To remove a DIMM:
1. Perform the service preparations shown on page 3-2, remove the workstation feet, and
place the workstation on its side.
2. Remove the following components:
side access panel
I/O bracket assembly
NOTE: If an AGP graphics controller is installed, you may want to remove it for easier access to
DIMM slot 1.
Press outward on both latches of the DIMM at the same time 1. This releases the DIMM
3.
and pushes it partially out of the socket.
Lift the DIMM from the socket 2.
4.
1
Figure 3-39. Removing a DIMM
To replace a DIMM, reverse the above procedure.
IMPORTANT: Before replacing the I/O bracket assembly, read "Important Guidelines for I/O
Bracket Assembly Replacement" earlier in this chapter.
NOTE: The system recognizes DIMM upgrades and automatically reconfigures the workstation.
2
1